Author Topic: Clipper  (Read 301 times)

Offline utpalruet

  • Full Member
  • ***
  • Posts: 213
  • Test
    • View Profile
Clipper
« on: August 12, 2014, 04:14:20 PM »
in electronics, a clipper is a device designed to prevent the output of a circuit from exceeding a predetermined voltage level without distorting the remaining part of the applied waveform.
A clipping circuit consists of linear elements like resistors and non-linear elements like junction diodes or transistors, but it does not contain energy-storage elements like capacitors. Clipping circuits are used to select for purposes of transmission, that part of a signal wave form which lies above or below a certain reference voltage level.
Thus a clipper circuit can remove certain portions of an arbitrary waveform near the positive or negative peaks. Clipping may be achieved either at one level or two levels. Usually under the section of clipping, there is a change brought about in the wave shape of the signal.
Clipping circuits are also called slicers, amplitude selectors or limiters.

Utpal Saha
Lecturer, Dept of EEE
Faculty of Engineering
ID: 710001154

Offline mahmud_eee

  • Hero Member
  • *****
  • Posts: 591
  • Assistant Professor, EEE
    • View Profile
Re: Clipper
« Reply #1 on: August 12, 2014, 04:25:35 PM »
carry on Utpol....
Md. Mahmudur Rahman
Assistant Professor, EEE
FE, DIU

Offline Kazi Taufiqur Rahman

  • Hero Member
  • *****
  • Posts: 514
    • View Profile
    • Kazi Taufiqur Rahman
Re: Clipper
« Reply #2 on: August 12, 2014, 07:37:29 PM »
Good post.
Kazi Taufiqur Rahman
Senior Lecturer, EEE