How to Repair Dodgy or Broken Headphones: Part-7

Author Topic: How to Repair Dodgy or Broken Headphones: Part-7  (Read 285 times)

Offline Md. Abrar Amin

  • Full Member
  • ***
  • Posts: 101
  • Optimistic
    • View Profile
    • Md. Abrar Amin
How to Repair Dodgy or Broken Headphones: Part-7
« on: April 22, 2017, 12:15:08 PM »

Strip off insulation. Use wire strippers, or carefully run a knife around the outside of the cable. Remove ½ inch (1.25 cm) of the outer shielding. Extend the cut in either direction until you see a broken wire. This is the area you'll need to repair.
If your cable looks like two cables glued together, each one will contain an insulated wire (the signal) and a bare wire (the ground).
Apple headphones and other headphones with single cables have two insulated wires (the left and right signal) and a single bare ground wire.
Md. Abrar Amin
Lecturer
Department of Electrical and Electronic Engineering
Faculty of Engineering
Daffodil International University (DIU)
Room # 601, Level-6, Main Campus
102, Shukrabad, Dhaka -1207
Mobile: +8801936556880