How to Repair Dodgy or Broken Headphones: Part-11

Author Topic: How to Repair Dodgy or Broken Headphones: Part-11  (Read 151 times)

Offline Md. Abrar Amin

  • Full Member
  • ***
  • Posts: 101
  • Optimistic
    • View Profile
    • Md. Abrar Amin
How to Repair Dodgy or Broken Headphones: Part-11
« on: April 22, 2017, 12:16:50 PM »

Solder the connections. Use a soldering iron to melt a small dab of solder over the wires. Repeat for each splice. Let cool.
Bare wires without insulation usually have a thin coat of protection. Sand this off or burn it off with the soldering iron before you solder. Avoid breathing in the fumes.[6]
Once cooled, wrap the two pairs of joins in electrical tape to ensure the red and white ends are kept separate from the ground wire.
Md. Abrar Amin
Lecturer
Department of Electrical and Electronic Engineering
Faculty of Engineering
Daffodil International University (DIU)
Room # 601, Level-6, Main Campus
102, Shukrabad, Dhaka -1207
Mobile: +8801936556880