Author Topic: How to 3D Print an Object: part-1  (Read 227 times)

Offline Md. Abrar Amin

  • Full Member
  • ***
  • Posts: 101
  • Optimistic
    • View Profile
    • Md. Abrar Amin
Md. Abrar Amin
Lecturer
Department of Electrical and Electronic Engineering
Faculty of Engineering
Daffodil International University (DIU)
Room # 601, Level-6, Main Campus
102, Shukrabad, Dhaka -1207
Mobile: +8801936556880

Offline Md. Abrar Amin

  • Full Member
  • ***
  • Posts: 101
  • Optimistic
    • View Profile
    • Md. Abrar Amin
Re: How to 3D Print an Object: part-1
« Reply #1 on: April 22, 2017, 04:31:06 PM »
Md. Abrar Amin
Lecturer
Department of Electrical and Electronic Engineering
Faculty of Engineering
Daffodil International University (DIU)
Room # 601, Level-6, Main Campus
102, Shukrabad, Dhaka -1207
Mobile: +8801936556880

Offline didarul alam

  • Full Member
  • ***
  • Posts: 109
  • Test
    • View Profile
Re: How to 3D Print an Object: part-1
« Reply #2 on: April 23, 2017, 02:31:18 PM »
Helpful post :)
Regards,

Md. Didarul Alam
Lecturer,EEE,DIU

Offline didarul alam

  • Full Member
  • ***
  • Posts: 109
  • Test
    • View Profile
Re: How to 3D Print an Object: part-1
« Reply #3 on: April 24, 2017, 02:42:03 PM »
 :) :) :)
Regards,

Md. Didarul Alam
Lecturer,EEE,DIU

Offline fahad.faisal

  • Hero Member
  • *****
  • Posts: 673
  • Believe in Hard Work and Sincerity.
    • View Profile
Re: How to 3D Print an Object: part-1
« Reply #4 on: May 24, 2018, 11:56:13 PM »
Thanks for sharing.
Fahad Faisal
Senior Lecturer
Department of CSE

Offline Nahid_EEE

  • Full Member
  • ***
  • Posts: 140
  • Lecturer, Dept. of EEE
    • View Profile
Re: How to 3D Print an Object: part-1
« Reply #5 on: May 26, 2018, 05:58:37 PM »
Thank you for your information.
M. Nahid Reza
Lecturer,
Dept. of EEE