How to 3D Print an Object: part-1

Daffodil International University

Simple Machines Forum

News:

Daffodil International University Forum contains information about Open Text material, which is only intended for the significant learning purposes of the university students, faculty, other members, and the knowledge seekers of the entire world and is hoped that the offerings will aide in the distribution of reliable information and data relating to the many areas of knowledge.

« previous next »

Print

Pages: [1] Go Down

Author Topic: How to 3D Print an Object: part-1 (Read 1271 times)

Md. Abrar Amin

Full Member
Posts: 101
Optimistic

How to 3D Print an Object: part-1

« on: April 22, 2017, 04:30:19 PM »

http://www.wikihow.com/3D-Print-an-Object

Logged

Md. Abrar Amin
Lecturer
Department of Electrical and Electronic Engineering
Faculty of Engineering
Daffodil International University (DIU)
Room # 601, Level-6, Main Campus
102, Shukrabad, Dhaka -1207
Mobile: +8801936556880

Md. Abrar Amin

Full Member
Posts: 101
Optimistic

Re: How to 3D Print an Object: part-1

« Reply #1 on: April 22, 2017, 04:31:06 PM »

this is more helpful: http://www.wikihow.com/Make-3D-Origami-Pieces

Logged

Md. Abrar Amin
Lecturer
Department of Electrical and Electronic Engineering
Faculty of Engineering
Daffodil International University (DIU)
Room # 601, Level-6, Main Campus
102, Shukrabad, Dhaka -1207
Mobile: +8801936556880

didarul alam

Full Member
Posts: 109
Test

Re: How to 3D Print an Object: part-1

« Reply #2 on: April 23, 2017, 02:31:18 PM »

Helpful post

Logged

Regards,

Md. Didarul Alam
Lecturer,EEE,DIU

didarul alam

Full Member
Posts: 109
Test

Re: How to 3D Print an Object: part-1

« Reply #3 on: April 24, 2017, 02:42:03 PM »

Logged

Regards,

Md. Didarul Alam
Lecturer,EEE,DIU

fahad.faisal

Hero Member
Posts: 734
Believe in Hard Work and Sincerity.

Re: How to 3D Print an Object: part-1

« Reply #4 on: May 24, 2018, 11:56:13 PM »

Thanks for sharing.

Logged

Fahad Faisal
Department of CSE

Nahid_EEE

Full Member
Posts: 140
Lecturer, Dept. of EEE

Re: How to 3D Print an Object: part-1

« Reply #5 on: May 26, 2018, 05:58:37 PM »

Thank you for your information.

Logged

M. Nahid Reza
Lecturer,
Dept. of EEE

Print

Pages: [1] Go Up

« previous next »

Page created in 1.543 seconds with 23 queries.