Author Topic: How to Tie the Knot!!!!!  (Read 643 times)

Offline Nur-E-Alam Siddique

  • Faculty
  • Jr. Member
  • *
  • Posts: 53
    • View Profile
How to Tie the Knot!!!!!
« on: November 22, 2011, 02:03:42 PM »
Instructions on How to Tie the Double Windsor Knot:


    The double Windsor knot requires you to wrap the wide part twice around the narrow part. This means that more length of the tie is required. Start by placing the tie around your neck with enough length showing on the wide side of the necktie. Place the wide part across, and above the narrow part of the tie at a 90 degree angle.
    Just like with the half Windsor tie knot, pull the wide part through the loop on the right side of your collar.
    Then pull the wide side of the tie back behind the narrow part.
    To make a double Windsor knot out of the half Windsor, do the same on the left side. Pull the half finished Windsor knot tight so both wrappings stay in place. Tip: Overlap both wrappings so that a triangular and symmetric shape appears.
    Hold the loop open that you created on the last wrapping with your left hand, and pull the wide end of the necktie through the loop.
    Slowly pull the Windsor tight
    Tighten the tie and flip down your shirts collars. Tying a double Windsor knot takes a little bit of practice. The most common mistake people make when tying a double Windsor knot, is in step 4. Make sure you overlap both wrappings. This ensures that the gap between both wrappings is closed which will prevent the tie from sliding into this gap. If this happens, the tie will not be centered on the Windsor.

Common mistakes people make when tying a double Windsor tie knot:

    The most common mistake people make when tying a double Windsor knot, is in step 4. Make sure you overlap both wrappings. This ensures that the gap between both wrappings is closed which will prevent the tie from sliding into this gap. If this happens, the tie will not be centered on the Windsor. If this is the case, open the tie knot and start from step 1.
    The tie is tied too short. Since the double Windsor knot requires two wrappings, you need to leave more length for the wide side of the tie. If this continues to be a problem then you might be too tall (above 6’3”) or have a wider neck. In your case, it is advisable to purchase extra long ties that are about 2-3 inches longer than a regular necktie. Common extra long ties measure about 59”-61”.

This page gives detailed instruction on how to tie a double Windsor necktie knot. Video and picture instructions on tying a perfect double Windsor tie knot are also available at Tie-knots.org – a website dedicated to teach men how to tie a tie properly.

source:Tie-knots.org

Offline Anisur Rahman

  • Faculty
  • Full Member
  • *
  • Posts: 193
    • View Profile
Re: How to Tie the Knot!!!!!
« Reply #1 on: November 22, 2011, 02:46:31 PM »
The post's really helpful. Thanks!
Anisur Rahman
Assistant Professor
Department of Computer Science and Engineering
Daffodil International University

Offline sethy

  • Hero Member
  • *****
  • Posts: 1069
    • View Profile
Re: How to Tie the Knot!!!!!
« Reply #2 on: November 24, 2011, 02:47:52 PM »
Very useful post........
Sazia Afrin Sethy
ID:101-11-1366
BBA Department,
Batch: 25th,
Sec: B.

Offline goodboy

  • Hero Member
  • *****
  • Posts: 1133
  • "Find your ways, Built your inspiration."
    • View Profile
Re: How to Tie the Knot!!!!!
« Reply #3 on: November 24, 2011, 09:18:46 PM »
Hmm...I think it can be Helpful. Thank you sir.
Md. Abul Hossain Shajib.
101-11-1375
Department of BBA, Sec:B.
25th Batch.
Daffodil International University.
Email: shajib_1375@diu.edu.bd
Admin Executive
creative.bd